Under high-wind uplift conditions, the EP01 Floor Plank can be bolted to the pedestal assembly. Each HW Fastener assembly contains three parts: T-Nut, Washer and Bolt with spring. The T-Nut locks into the bottom of the EP28 Multiplate. The Washer snaps onto the EP38 Pin Block once the EP01 Floor Plank is placed onto the Multiplate. The Bolt when dropped into the opening will stand upright and in vertical alignment to the T-Nut. Thread tight using the T25 drive bit. Can be withdrawn at anytime for future Floor Plank removal.
Dimension • 5/16-18 thread x 3/4"
Material • engineered plastic
Color • cream
Pack Quantity • 50
Included • T-25 drive bit
Use • insert T-Nut into bottom of Multiplate, assemble floor plank, insert washer, insert bolt, screw to fixture